A couple of questions about HD weight installation

Product support and suggestions and all other things related to BoreBuddy products

Moderator: Renaissanceman

Post Reply
mecompco
Posts: 4
Joined: Sat Mar 13, 2021 3:26 pm

A couple of questions about HD weight installation

Post by mecompco »

CMMG bolt w/around 300 rounds on it, freshly cleaned, just delivered BB Mega Bundle.

I'm assuming from the instructions that the notch on the end of the weight must "lock" in under the recoil spring rod "nub" so that it can't easily be dislodged from the side. Is there a possibility that the weight, due to tolerances of bolt weld, will not lock in? It sort of gets in there and looks pretty straight but tip it and the weight falls out to the side. Any advice would be much appreciated.
mecompco
Posts: 4
Joined: Sat Mar 13, 2021 3:26 pm

Re: A couple of questions about HD weight installation

Post by mecompco »

Went at it with some calps, distance seems just about equal at 1.804". Perhaps I'm wrong about the weight needing to be captured from side-to-side movement, it is captured for forward and back movement. Install instructions could be more specific about the proper fitment of the weight.
Post Reply